Improvements
- Antenna selection remains the same for both RX and TX
- More TX power control settings (0 – 18dbm)
- Power control works on all modes
- Additional channels (12, 13 and 14)
- Better web interface
Screenshots
ChangeLog
- 08-01-2005 – v0.6
- Unlocked european channels 12 and 13 and japanese channel 14
- 30-12-2004 – v0.5
- TX power control now works for all devices.
- Added even more TX power settings (0 – 18dbm).
- Added “* scans on current channel only” note to adv_mode.html.
- 27-12-2004 – v0.4
- Fixed antenna selection. Now works the same for both TX and RX.
- Changed “Good packets” to “Total packets” in st_stats.html.
- Changed Right and Left Antenna to Internal and External in adv_perf.html.
- Added modification version and date to tools_firmw.html
- 26-12-2004 – v0.3
- Added URL to tools_firmw.html.
- Added photo of D-link PCB.
- Changed banner photo – added credits 😉
- 25-12-2004 – v0.2
- TX power setting in effect for all modes.
- 24-12-2004 – v0.1
- Added more TX power setting on AP mode only (1 – 17dbm).
7 thoughts on “DWL-900AP+ rev.C Modified firmware”
can you please modify the firmware so that the power can be set at 20db instead of 18db antenna power.
thanks
pinel
I could, but setting ΤΧ power over 18dBm causes severe distortion and lowers effective rates.
At D-Link support there is a “Firmware version 3.09 (h/w rev Cx) 30-06-2005”. Are there any siginificant changes in this release compared to the 3.06 or 3.07 version?
Is there a reason for not modifing the newer versions?
Thanks.
On later than 3.06 versions, a md5 checksum was added to make modding more difficult.
Hi and tnks for your work !!!
I have a question: I have two DWL 900 AP+, rev. C. I have tried to put them working in bridge mode with your firmware but they don’t. I have used MAC-ADDR of Ethernet interface. Do u have any suggestions ?
Thanks in advance.
hi, hi used Acinonyx firmware 3.06.06 for dwl900ap+ rev c2
is wlan wifi is issue
my net wifi works for a sure period then to scompare, contretto to extinguish and to relight AP. with firmware it originates them this does not happen. how I can resolve the problem using your to firmware?
Hi, your latest modded firmware on which D-Link version is based?
So, after the 3.06 version the only chenges where added md5 checksum or..?
Tnx.